05-07-2022, 12:50 PM (Edited 05-07-2022, 12:57 PM by Mikey.)
(05-07-2022, 12:45 PM)Zizou Wrote: Need 4 or 5, can you deffo buy them there aye? I can't see it online.
Just looked. Think you need to order 100 quids worth. So probably talking at least 10. Not sure you'd be able to get 4 or 5 at any builder's merchants.
Wickes at Stevenson Road the only other place I can think where you could just get them from the shop.
Think Fraggle is right. Never fitted one of those so not certain. The only other way I can think of is if there's screws on the bottom grill, you can unscrew them and pop that off then there would be a couple of screws for the front panel and then tilt and lift it off. That's how most modern storage heaters are built
(06-12-2022, 11:58 AM)Herzog Wrote: Putting up some Ikea shelving units.
I dont think theres ever been a time when ive been fixing up Ikea stuff where ive not convinced myself theres a screw or bolt missing
whenever I build anything from ikea I normally open the screw pack on top of the page with the contents list and pair them up with the pictures before starting to ensure everything is there, don't think I've ever been short but some of the screw sizes can be very similar.
Anybody know how to fix uneven gas burners? They were working fine before. I've taken them off to get cleaned as I normally do and now 5 of the 6 burners are uneven as fuck with half a flame, some massive flames in flames and some tiny flames in other places and one just refuses to even light.
(06-12-2022, 11:58 AM)Herzog Wrote: Putting up some Ikea shelving units.
I dont think theres ever been a time when ive been fixing up Ikea stuff where ive not convinced myself theres a screw or bolt missing
(06-12-2022, 02:55 PM)Rory Breaker Wrote: whenever I build anything from ikea I normally open the screw pack on top of the page with the contents list and pair them up with the pictures before starting to ensure everything is there, don't think I've ever been short but some of the screw sizes can be very similar.
Putting up spare beds and there was a screw that hadn't had the screw head drilled at all - just a totally smooth Phillips head
Luckily it was just for a popper that attaches the two beds together.
(08-02-2022, 11:09 AM)CM Kash Wrote: Anybody know how to fix uneven gas burners? They were working fine before. I've taken them off to get cleaned as I normally do and now 5 of the 6 burners are uneven as fuck with half a flame, some massive flames in flames and some tiny flames in other places and one just refuses to even light.
The black tops or the bit underneath too? If it's the black boys just turn them on and tap it down with a screwdriver and it should right itself. If the sliver bit is wrong turn it and it'll drop into the correct bit.